Inspect a Forklift
There are over 10,000 workplace injuries connected to forklifts occur every year, based on OSHA and HRSDC reports. A lot of these accidents are caused by operator error. Lack of proper equipment maintenance and check causes numerous others. Forklift maintenance and operation is not just the cause of personal injuries, but also of damage to property. Forklifts can damage overhead pipes, sprinklers and building structures, and other machinery when incorrectly utilized. The following daily check ups should be carried out in order to lessen the chance of forklift accidents.
Turn the engine off before checking different fluid levels: fuel, engine oil, hydraulic oil, coolant and brake fluid. The tires should be inspected for signs of wear and tear. Check the tire air pressure. Check the condition of the forks. The load backrest should be attached firmly. Do a visual check of the top-clip retaining heel and pin. Afterward carry out an inspection of the mast chains, hydraulic hoses, stops and cables. Make sure that both the overhead and finger guards are securely attached.
The LP powered forklift has propane tanks that need to be inspected for rust, corrosion or damage. The battery's electrolyte levels and charge have to be tested periodically. Seat belts have to be checked for wear and tear. Check to make sure the owner's guidebook is stored on-board the forklift in a storage compartment. Test the seat belt to make sure the latches are secure. Check the hood latch to ensure it is working as it should.
To make certain there are no unusual engine sounds, start the engine up and listen for any irregularities. If there are, investigate immediately. Check the accelerator and the steering controls. The service brake and the parking break must be correctly functioning.
To ensure proper functioning in both forward and reverse, the tilt control and drive control must be checked. The functioning of the hoist, the lowering control and attachment control requires periodic checking. Test the horn and lights. Then check the heater, defroster and wipers to make certain they are functioning smoothly. Check each and every gauge to ascertain that it is reading within functional limits.